Amazingly I can see the light at the end of the insulation tunnel. A couple more finish panels in the cockpit, the rear, and floor is all that is left.
I decided to take a little break from the polystyrene and fix the remote start in the engine bay. I was pretty sure the bus wasn’t going to start in the cold weather but at least it will be ready later. New starter switch and engine bay lamp switch. I cleaned the gauge up a bit too. Now I can fire it remotely which is cool.
Still needs the key switch in the on position though.
Oh OK, here are a few insulated bus shots too. I should draw future window frames on the walls.
